Table of Contents
Advertisement
CHAPTER 3
7) Remove the 5 screws and the shield
plate.
Screws
Shield plate
Figure 3-8-13
8) Remove the DC controller PCB following
steps 1-4 on Page 3-43.
9) Remove the 3 screws.
10) Remove the claw and take out the DC
controller mounting plate.
Screws
Claw
DC controller mounting plate
Figure 3-8-14
3 - 46
11) Disconnect the connector, remove the 2
screws,
and
pull
Disconnect the other connector and
remove the switch/sensor PCB.
Connectors
Screws
Switch/sensor PCB
Figure 3-8-15
out
the
board.
Advertisement
Table of Contents
Troubleshooting
