Transfer Charging Roller - Canon LBP-3260 Service Manual

CHAPTER 3
F. Transfer Charging Roller
1) Open the upper cover.
2) Open the transfer charging roller guide.
3) Pinch the gear, lift it slightly, and slide
it to the left. Remove the transfer
charging roller.
Transfer charging roller guide
Gear

Transfer charging roller

Figure 3-4-9
< Notes for reassembly >
Hold the shaft and bushing, not the sponge
area, of the transfer charging roller when
installing the roller.
3 - 18
G. Fixing Roller Heater
1) Remove the fixing unit following steps
1-2 on Page 3-13.
2) Disconnect the 2 claws that hold the
wire cover to the fixing unit, and then
remove the wire cover.
Claws Wire cover
Figure 3-4-10
3) Unhook the claw, and then remove the
fixing entry guide.
Claw Fixing entry guide
Figure 3-4-11