Canon SmartBase MPC400 Service Manual page 98

SmartBase MPC600F/MPC400 Chapter 4: Maintenance & Service
"CHECK PAPER SIZE"
Cause:
Solution:
"CHECK PRINTER" (##332~##337, ##342, ##345, ##346 and ##348)
Cause:
Solutions:
"CLEAR ADF" (SmartBase MPC600F only)
Cause:
Solution:
"CLEAR PAPER JAM" (#009)
Cause:
Solution:
"COVER OPEN"
Cause:
Solution:
"DOC. TOO LONG" (#003)
Cause:
Solution:
Cause:
Solution:
"K INK EMPTY"
Cause:
Solution:
"LOAD PAPER" (#009)
Cause:
Solution:
The size of the paper loaded in the paper cassette is different from the paper size
set by user data.
Select a correct paper size by pressing Paper select button.
The printer's internal unit has malfunctioned.
(1) Remove the jammed paper. (Check the paper edge sensor is OFF.)
(2) Press Resume button.
(3) Reinstall the Cartridge.
(4) Turn the power off and on.
(5) Set the service data #1 SSSW SW01 bit 0 to "1" and check the service code.
Refer to the countermeasures for that error code.
A paper jam occurred in the ADF.
Remove the document you are trying to copy or send from the ADF and press the
Resume button. Then start again.
Paper jam.
Clear the paper jam and press the Resume button.
You opened the flatbed ass'y during an operation.
close the flatbed ass'y.
The document is longer than 39.4"(1m).
Use a copy machine to make a reduced copy of the document. Then send again.
It took more than 32 minutes to send or copy a document. It took more than 32
minutes to receive a document.
Divide the document and send or copy each part separately. Contact the other
party. Have them divide the document and send each part separately.
The Black ink tank in the BJ cartridge is empty.
Replace the Black ink tank.
The fax is out of paper.
Add more paper to the auto sheet feeder. Make sure the stack is below the limit
mark and press the Start or Resume button.
4-14