Canon SmartBase MPC400 Service Manual page 167

SmartBase MPC600F/MPC400 Chapter 4: Maintenance & Service
a-3) Service activity report (sending/receiving)
Figure 4-39 Service Error Tx Report
Header : OK, NG messages
TX/RX NO
: Indicates four digits of the transaction number
CONNECTION TEL
: Number sent from the other party or number dialled (lower 20 digits)
(OTHER PARTY)
SUBADDRESS
: Subaddress number sent from the other party
CONNECTION ID : ID sent from the other party, if the other party is a Canon fax
START TIME
: Communication start date and time (on 24-hour display)
USAGE TIME : Communication time (in minutes and seconds)
PAGES
: Number of pages for which transmission was complete
RESULT : "NG" display with number of pages for which transmission was
MAKER CODE : Maker code
RCV V.8 FRAME : Received V.8 protocol signal
SYMBOL RATE
: Symbol rate used for the primary channel
TX LVL REDUCTION : 0 (Fixed)
ERR ABCODE : Code output by the modem when an error occurred (Not used in the field)
ERR SECTXB
: Transmit status of the modem when an error occurred (Not used in the
field)
ERR SECRXB
: Received status of the modem when an error occurred (Not used in the
field)
RX/TX
: Received/transmitted protocol signal
bit 1 to bit 96 of received/transmitted DIS, DCS, or DTS
The V.8/V.34-related items (RCV V.8 FRAME to ERR SECRXB) are not printed on the
Notmal G3 Service Activity Report.
NOTE
(For details, see User's manual )
fault, and service error code
[1000 1000]
Indicates a Canon fax
lower nibble
upper nibble
4-83