8 ] Installing The Body Cover And - Brother PT-2500PC Service Manual

[ 8 ] Installing the Body Cover and Front Cover
(1) Connect the sub PCB flat cable to the main PCB.
NOTE: Insert the cable end into the connector with the solder side facing towards
the cutter motor.
(2) Fully open the cassette cover. and hold the body cover as shown below.
(3) Hold the body cover as shown below, then connect the sensor PCB flat cable and
tape end sensor harness to the main PCB.
NOTE: Insert the cable end into the connector with the solder side facing towards
the power supply PCB.
Fig. 2.2-35 Connecting the Sub PCB Flat Cable, Sensor PCB Flat Cable, and Tape End Sensor Harness
(4) Align the four holes provided in the body cover with the four poles provided on the
frame ASSY, then fit the body cover and bottom cover together.
Fig. 2.2-36 Fitting the Body Cover and Bottom Cover Together
II - 33