Brother PT-2500PC Service Manual page 35

(8) Set the roller holder release spring on the roller holder ASSY so that its straight end
is fitted to section "A" on the ASSY, and install the ASSY with the spring to the head
frame. Then hook the spring's bent end on section "B" provided on the head frame.
NOTE: Take care not to let the roller holder release spring scratch the thermal head
and flat cable.
Fig. 2.2-21 Installing the Roller Holder ASSY
(9) Fit the arm of the cassette rod in the sector hole of the release lever and set the
cassette rod on the shaft of the frame ASSY.
(10) Secure the cassette rod with the retaining ring.
(11) Put the tape feed motor on the frame ASSY and bring its edge into contact with the
boss. Then secure the motor with the two screws.
Fig. 2.2-22 Installing the Cassette Rod and Tape Feed Motor
II - 23