Installing The Thermal Head Unit, Roller Holder Assy, And Tape Feed Motor Onto The Frame Assy - Brother PT-2500PC Service Manual

[ 2 ] Installing the Thermal Head Unit, Roller Holder ASSY, and Tape Feed Motor onto the
Frame ASSY
(1) Fit the release rod roller into the release rod.
(2) Apply grease (Silicone grease G501) to the inside edge of the square hole provided
in the release rod and the surface of the release rod roller.
(3) Install the release rod on the head frame so that the guide slits become fitted over
the guide shafts provided on the head frame.
(4) Install the release lever to the head frame so that hole "a" becomes fitted over the
longer guide shaft on the head frame and boss "b" becomes fitted in the square hole
in the release rod.
(5) Secure the release lever with the retaining ring.
(6) Hook the release lever spring over the release lever and head frame.
Fig. 2.2-19 Installing the Release Rod and Release Lever onto the Head Frame
(7) Pass the head flat cable through the slot provided in the frame ASSY, then secure
the thermal head unit with the two screws.
Fig. 2.2-20 Installing the Thermal Head Unit
II - 22