Brother FAX4100 Service Manual page 96

Reassembling Notes
• When connecting the power inlet to the low-voltage power supply PCB, insert the brown and
blue lead wires into eyelets L and N in the PCB, respectively, and then solder those wires on the
solder side of the PCB.
• After setting the power inlet back into place, fold the grounding wire into two and route the fold
through cutout "Y" provided in the support film as shown on the previous page.
• When reinstalling the low-voltage power supply PCB, route the main-LV-engine harness through
cutout "X" provided in the support film as shown on the previous page.
IV - 55