Brother FAX4100 Service Manual page 54

(7) Remove the document take-in roller gear (in the direction of arrow Q) by pulling its pawls
outwards. Slightly push down the arm (arrow R) and shift the document take-in roller shaft to
the left (arrow S) and take it up.
Then shift the document take-in roller to the left and take it up.
(8) Remove the separation roller gear (in the direction of arrow Q) by pulling its pawls outwards.
Slightly push down the arm (arrow R) and shift the separation roller shaft to the left (arrow S)
and take it up.
Then shift the separation roller to the left and take it up.
(9) Remove the two pressure roller leaf springs by pulling them in the direction of arrows Q and R
in this order as shown below. Then remove the pressure rollers and shaft.
(10) Remove the two control panel locks (leaf springs) with a flat screwdriver in the direction shown
below.
IV - 13