Brother FAX4100 Service Manual page 75

CAUTION: When securing the halogen lamp to the lamp lock plate with the screw, be sure to
use the plastic jig as shown below to avoid damaging the edge of the FU lamp with a
screwdriver.
Halogen lamp
(9) Take the heater roller out of the upper FU frame.
(10) At the gear side of the heater roller, remove the HR gear 34, retaining ring 25, washer 25, and
bushing 25 in this order.
At the other end of the heater roller, remove the bushing 25.
CAUTION: Do not touch the surface of the heater roller. If you have touched it, clean it
thoroughly with dry, lint-free cloth.
Bushing 25
Lamp lock plate
Heater roller
Retaining ring 25
IV - 34
Screw
Plastic jig
Gear side
Bushing 25
Washer 25
HR gear 34