Management VLANs
Changing the Management VLAN Through a Telnet Connection
Command
Step 1
configure terminal
Step 2
cluster management-vlan
vlanid
Step 3
show running-config
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
8-6
Before you start, review the
Beginning in privileged EXEC mode on the command switch, follow these steps
to configure the management VLAN interface through a Telnet connection:
Purpose
Enter global configuration mode.
Change the management VLAN for the cluster. This ends
your Telnet session. Move the port through which you are
connected to the switch to a port in the new management
VLAN.
Verify the change.
"Management VLANs" section on page
Chapter 8
Configuring VLANs
8-4.
78-6511-05