Table of Contents
Advertisement
position that can become critical when using reflective or notched stock with a
small TOF mark. Three required readings are:
Empty:
No media in the Media Sensor.
Mark or Gap: Only the backing (liner) material, notch, or reflective mark in the
sensor.
Paper:
With an unmarked label area (a space without pre-printing) in the
sensor.
To perform a Standard Calibration:
Step
Operator Action
1
Turn 'On' the printer.
2
Press the
Menu Mode.
Lift the printhead for visual
access to the Media Sensor
and load label media.
3
Press the
enter the Media Settings
menu.
4
Press the
5
Press the
the
to the desired sensor type
and press the
to enable the selection.
(Continued next page)
52
key to enter
key to
key.
key. Use
key to scroll
key
Displayed Message
Comment
Wait until
'Ready' is
displayed.
See Section
4.0.2 for
details.
See Section
4.1.1 for
details.
See Section
4.1.1 for
details.
See Section
4.1.1 for
details.
The enabled
selection will
be indicated
with an *
.
Advertisement
Table of Contents
