Table of Contents
Advertisement
Calibration Problems: When problems occur during calibration, one of the
following messages will be displayed. The 'Comment' column addresses the
most likely cause and the corrective action to be taken (if any) for each situation.
Displayed Message
Or:
Displayed Message
Or:
Displayed Message
56
Action
Press any key. The printer measured only a small
difference between the 'empty' and
'gap' readings. Transparent
backing or notched type media
typically gives this indication. In
this case, there may be a slight
delay in the 'Out of Stock'
indication, after the media supply is
emptied.
Action
Press any key. Only a small difference or no
change in low sensor readings was
detected. Ensure that nothing is
stuck in the media sensor. Retry
calibration. If the problem persists,
perform the 'Advanced Entry
Calibration'; see Section 5.3.2. If in
reflective mode – REFLECTIVE
MODE will be displayed instead of
GAP MODE.
Action
Press any key. Consistently high readings were
received which could indicate a
faulty sensor. Ensure that no labels
stuck in the media sensor. Retry
calibration. If the problem persists,
perform the 'Advanced Entry
Calibration'; see Section 5.3.2. If in
reflective mode – REFLECTIVE
MODE will be displayed instead of
GAP MODE.
Comment
Comment
Comment
Advertisement
Table of Contents
