3.3.2
Winding with the Peel and Present Option
The printer can separate the labels from the backing material "on-demand"
when equipped with the Peel and Present Mechanism. Complete the following
steps for automatic separation:
n
With media loaded as described
in Section 3.2, and the Peel and
Present Mechanism installed on
the printer, loosen the two
Thumbscrews on the front of
the Roller Bracket, allowing the
bracket to swing down.
o
Press
the
advance
approximately
inches of media from the front
of the printer.
p
Remove the labels from the
backing material.
q
Route the backing through the Roller Bracket, as shown below; next, raise
the Roller Bracket and tighten the two Thumbscrews.
(Continued next page)
20
FEED
key
and
20