3.2.2
Fan-Fold Media
n
Bring the media in through the Bottom or the Rear Media Slot.
o
Route the media as shown below: over the Media Hanger (or Rotating
Media Hub) when entering through the Rear Media Slot; or if entering
through the Bottom Media Slot, route the media over the Media Rewind
Hub.
p
Continue routing the media under the Media Idler, through the Media
Sensor and out the front of the printer.
q
Raise and slide the Media Guide (and Media Retainer if Media Hanger
equipped and using the Rear Media Slot) over to rest lightly against the
media's edge.
r
Slide the Media Sensor into position; see Section 5.1 for details.
s
Lower the printhead and rotate the Printhead Latch back to the locked
position. Close the Access Cover.
)
If you are printing with thermal transfer media, see Section 3.4 for ribbon
loading instructions.
)
If you have a thermal transfer printer but will be printing on direct thermal
labels, see Section 4.1.1 for instructions to select direct thermal media in
the Media Settings menu.
17