Table of Contents
Advertisement
4.1.1
Media Settings
From Ready Mode, press the
; ;
Note: Entering the menu will clear memory of any settings sent from the
host – unless the host has reset the printer.
MEDIA TYPE
DIRECT THERMAL
—
THERMAL TRANSFER For use with media requiring a ribbon to
SENSOR TYPE
—
GAP
CONTINUOUS
REFLECTIVE
LABEL LENGTH
— —
04.00in (0-99.99)
MAXIMUM LABEL LENGTH
—
16.00in (0-99.99)
SENSOR CALIBRATION
PERFORM CALIBRATION The User enters the empty, gap or mark and
ADVANCED ENTRY
SENSOR GAIN
SENSOR LEVELS
key to enter the Menu Mode.
Selects a print method.
For use with heat sensitive media.
create an image.
Selects the top-of-form (TOF) sensing
method for the media.
The printer recognizes the TOF by sensing
gaps in the media.
No TOF sensing. The user must use the
LABEL LENGTH setting to determine TOF.
The printer recognizes the TOF by sensing
registration (black) marks on the underside
of media.
For use with continuous media. Label length
is used to determine the TOF when 'Sensor
Type-Continuous' is selected.
Sets the maximum length between TOF
marks (gap or black stripe). If this limit is
exceeded, a top of form fault is declared.
Adjusts the printer to sense your media.
paper values to set the media sensor.
User directly inputs the best gain values to
adjust the media sensor.
Observe A/D reading and set SENSOR
GAIN. Adjusts the sensitivity of the sensor
for custom label stock. Higher gain means
more sensitivity; however, when set too high
the printer loses the ability to distinguish
gap or mark from paper.
Sets threshold values for the media sensor
parameters. Entry for paper, gap/mark, and
empty thresholds.
31
Advertisement
Table of Contents
