Table of Contents
Advertisement
Operation
Safety Instruction
CAUTION !
Risk of injury by bruising hands at moving parts. That matters especially for the movement of the
peel-off table, the main cylinder and the pad. Keep away your hands from those danger spots.
Note the warning labels on printer and applicator.
Important Information about Operation with PAM 3603
NOTICE !
For operation with PAM 3603 it is absolutely necessary to activate permanently the signal ESP on
the PLC interface.
Otherwise the error message "Lower position" would appear during the labelling cycle and the
labelling would fail.
For detailed information on the PLC interface see the Operator's Manual.
Switch on the Printer Applicator System
-
Check all external connections before starting to print.
-
Make sure that the media is loaded corresponding to the instructions.
-
Check that the transfer ribbon is loaded properly before starting to print.
CAUTION !
Make sure that the slide valve of the lift cylinder is closed during operation.
Otherwise the lift cylinder can be moved without control. This fact can cause damages.
NOTICE !
Make sure that the pad is not covered by a label when switching on the device.
1
Fig. 20 Power switch
-
Switch on the compressed air supply.
-
Switch on the power switch (1) of the Printer Applicator System.
The printer carries out a short system test and following the display shows the system mode "Ready".
If a hardware failure occurs during the system test the type of the failure will be shown. In this case the
printer should be switched off and on again. If the failure occurs again call for service.
Standard Operation
NOTICE !
Before starting the first print job after switching on the printer it is necessary to synchronize the
label feed :
-
Press the
-
Start the print job.
-
Start the labelling process via PLC interface.
Printer Applicator System PAM 3600
key to generate a synchronous running. Remove the processed labels manually.
Operation
21
Advertisement
Table of Contents
