Table of Contents
Advertisement
Media Loading
Media Loading
Loading Labels
1 5
1 4
1 3
Fig. 13 Loading labels
CAUTION !
Risk of injury by moving parts. Disconnected the Printer Applicator System from the compressed
air during label loading.
1.
On the media hub (4) there are a flange (7) and two adapters (3).
Loosen the knurled screw (8) and remove the flange (7).
2.
Slide the first adapter (3) after loosening the knurled screw (5) to the wind plate (6) until it blocks.
Tighten the knurled screw (5).
3.
Place the second adapter in such a position, that the distance between the outer edge of the
adapter and the wind plate (6) is a little less than the width of the label roll.
4.
Place the label roll (2) onto the adapters (3) and slide it against the wind plate (6).
5.
Put the flange (7) on the supply hub (4), slide it against the label roll (2) and fix it by tightening the
knurled knob (8).
6.
Loosen the set screws in the media guide rings (1) and slide the guide rings outwards as far as
possible.
7.
Unlock the transport locking roller (14) by pressing the knurled knob (15) downwards.
8.
Unroll a length of label stock from the media roll and feed it first to the printhead (13) as shown in
figure 13.
14
1
2
1 2
1
3
4
5
6
1
11
1 0
9
Printer Applicator System PAM 3600
7
8
Advertisement
Table of Contents
