Mackie Spike User Manual page 42

Overview screen continued
The Overview Screen
DSP Selection and Ordering buttons
You can enable or disable the individual DSP modules by clicking the buttons in this section. This is
the same as clicking on the ACTIVE button in each DSP module window. If you right-click and drag
(control+click on a Mac), you can rearrange the order of the DSP modules in the signal path.
Output faders
Click and drag on these faders to adjust the output level of each channel, from Off to +10 dB, where
0 dB is unity gain. A numerical gain readout appears just above the output faders. The faders control
the output level of the DSP, which is effectively the input level going into Tracktion. Ctrl-click to re-
turn to the default level.
Link All and Link Faders
When the LINK ALL button is on, the output faders and all DSP controls are linked between chan-
nels 1 and 2. If you adjust a channel 1 control, channel 2's corresponding control will also move.
When the LINK FADERS button is on, only the output faders are linked.
Note: Each DSP module has its own Link button, so you can always choose which modules
are linked, in case you don't want to Link them all (see page 50).
When LINK ALL or LINK FADERS is selected, the channel 1 settings are
copied over to channel 2.
DSP Select/Order Output Faders Link All
Link Faders
User's
42
Guide