Mackie Spike User Manual page 44

Setup screen continued
Save
Template
Load
Template
Reset
Controls
The Setup Screen
Load Template button
Click this to load the template settings to the XD-2. This overwrites all current settings and cannot
be undone, so use it with care, perhaps counting to ten, or humming a little song before clicking. Use
it if you want to return to your start up settings without having to quit and restart the XD-2 software.
Reset Controls button
Click this button to return all the controls in the XD-2 Software to their default factory values.
Sample Clock Selection
Select XD-2 to use the Internal sample clock (the default) as the master reference. Always select
S/PDIF when recording from a connected S/PDIF device.
Clock Lock Detection
This shows when the XD-2 is locked to either XD-2 or S/PDIF clock source.
Note: If the Sample Clock Selection is set to S/PDIF, this should always light when re-
ceiving a valid clock from your external S/PDIF source device. If not, check your S/PDIF
connection and the source device. It should always be on if the Sample Clock Selection is
set to XD-2. If not, reboot the computer or turn the XD-2 power on or off.
Sample Clock Selection
Clock Lock Detection Max Sample Rate Mode
Monitor Source
USB Connection Established
User's
Guide
44