Inserting And Removing A P2 Card; Inserting A P2 Card; Removing A P2 Card; Preventing Accidental Deletion - Panasonic AG-MSU10 Operating Instructions Manual

Inserting a P2 Card

1
Insert a P2 card in the P2 card slot.
• Press in the card until the EJECT button
pops up.
 NOTE:
• Be sure to hold the P2 card level as you insert
it and slide it in as far as it will go. Forcing cards
into the slot at an angle may damage them.
2
Fold the EJECT button in the direction of
the arrow.
0

Inserting and Removing a P2 Card

EJECT button EJECT button

Removing a P2 Card

1
Flip up the EJECT button in the direction
of the arrow.
2
Press the EJECT button.
• Remove the P2 card when it pops out.
• Do not remove a P2 card when the P2
card access LED (P2) is flashing. Other-
wise the data may become corrupted and
the P2 card could be damaged.
 NOTE:
• A P2 card that has just been used may be very
hot and must be handled with care when removed.
Preventing Accidental
Deletion
Set the write-protect switch to [PROTECT] to prevent
accidental deletion of data recorded on a P2 card.
P2 card P2 card
PROTECT PROTECT
 NOTE:
• A write-protect switch setting made during copying or
access will not take effect until the current read or write
operation ends.