- Insert the microP2 card adaptor. (Fig. 4) Insert the microP2 card adapter into the card slot with the logo facing upwards until the eject button pops

out. (Fig. 2)

Press the eject button that pops up to the right (Fig. 3)

Make sure that the P2 card access LED illuminates in orange or green. (page 43)

When two P2 cards are inserted in the card slots, the P2 card with the smaller slot number will be recorded to first. Note, however, that regardless of

the slot number, if a P2 card is inserted later, that P2 card will not be accessed until the previously inserted P2 card has been recorded to.

f Example: When P2 cards are inserted in two slots

If both slots contain P2 cards, the P2 cards are recorded in order from slot number 1 → 2. However, if the P2 card in slot number 1 is removed and

then re-inserted, the P2 cards will be used in the following order: slot number 2 → 1.

The P2 card number to be recorded to is held even if the camera is turned off. When the camera is next turned on, recording can be continued to the

same P2 as before the camera was turned off.

Close the card slot cover.

NOTE

t Be sure to close the card slot cover in order to prevent dropping, dust, and static electricity.

t Be sure to format P2 cards only on a P2 device.

t If SDHC/SDXC memory cards other than microP2 memory cards are used in the microP2 card adaptor, operation is not guaranteed.

Removing a P2 card

Open the card slot cover.

Remove the card.

Lift the eject button (Fig. 1), and press in. (Fig. 2)

NOTE

t After insertion, do not remove the P2 card while it is being accessed or recognized (the P2 card access LED is flashing orange). Doing so may result

in a malfunction.

t If you remove the P2 card while it is being accessed, [E-30] [TURN POWER OFF] is displayed in the viewfinder and the camera informs you of

warning via the tally lamp, etc. All P2 card access LEDs flash rapidly in orange. Turn off the power. (page 203)

t If the P2 card is removed while being accessed, clips on it may become irregular. Check the clips and restore them, if required. (page 108)

t If the P2 card is removed while it is being formatted, formatting of the removed P2 card is not guaranteed. In this case, [E-30] [TURN POWER OFF] is

displayed in the viewfinder. Turn the power off and then on again, and reformat the P2 card.

Chapter 3 Preparation — P2 card

Eject button

P2 card access LED

Fig. 2

Fig. 1

– 42 –

Fig. 3

Fig. 2

Fig. 4

Table of Contents