Panasonic AG-MSU10 Operating Instructions Manual page 47

Message
STORAGE The unit has been disconnected from the
DEVICE storage device.
DISCONNECTED!
SYSTEM Last copy or format operation failed due to
ERROR! a system control error.
TOO MANY Too many clips are selected.
CLIPS!
TOO MANY There are too many folders on the storage
FOLDERS! device.
TOO MANY There are too many partitions on the stor-
PARTITIONS! age device.
TOO MANY There are too many devices connected to
TARGETS! hubs.
TURN POWER Displayed when an error occurs in read-
OFF! ing and writing P2 card or storage device
data.
UNKNOWN An attempt was made to process an un-
CONTENTS known clip (clip version not supported by
FORMAT! this unit) or a bad clip.
UNKNOWN An unsupported DVD drive or unsupport-
DEVICE ed device is connected.
CONNECTED!
VERIFICATION The contents of the copied data do not
FAILED! match.
WRITE The P2 card is write protected.
PROTECTED!
Description Measure
Connect the storage device properly. If
the device still does not operate normally,
turn it off and turn it back on again.
Copy or format again.
Reduce the number of selected clips.
The maximum number of folders is 100.
Use a new storage device or a formatted
storage device.
Storage devices can handle up to 23
partitions. Use a new or formatted storage
device.
Disconnect the device, turn off the unit
and turn it back on again.
To continue operation, turn the power off
and then back on again.
Use only clips that are supported by the
unit.
Restore bad clips on the device that
recorded them or delete them.
Disconnect the device, turn off the unit
and turn it back on again.
Copy the data again.
Insert write-enabled media.