Control Reference Guide - Panasonic AG-MSU10 Operating Instructions Manual

1.
AG-MSU10 connector
Connector for connecting the interface box to
the AG-MSU10 Mobile Storage Unit.
2.
USB 2.0 connector (POWER connector)
Use the USB cable to connect this connector
to a USB 2.0 connector on a personal com-
puter to power the drive from the computer.
3.
USB 2.0 connector (SIGNAL connector)
Use the USB cable to connect this connector
to a USB 2.0 connector on a personal com-
puter to power the drive from the computer
and to transfer data between devices.
4.
WARNING LED
Lights to indicate that not enough power is
supplied.
 For details, refer to "Checking Bus Power
Operation" (page 44).
5.
POWER/ACCESS LED
Green: Power is supplied and the device is
ready to use.
Red: The host is accessing the device.
 NOTE:
• POWER/ACCESS LED operation depends on
the installed SSD.

Control Reference Guide

6.
eSATA connector
Use the eSATA cable to connect this con-
nector to an eSATA connector on a personal
computer.
 NOTE:
• The eSATA connector does not supply power.
Use the USB cable to supply power.
• Use double shielded cable for making connec-
tions to eSATA connectors.