Before Requesting A Repair; Maintenance; Condensation - Panasonic AG-MSU10 Operating Instructions Manual

Mobile storage unit

Hide thumbs Also See for AG-MSU10:

Brochure (2 pages)

Table Of Contents

Table of Contents

When the unit does not seem to operate normally, first check the following information. If the problem still

persists, consult your supplier.

Power supply issues

Symptom

The unit does not

•

The battery and AC adapter may not be correctly connected.

Check the connections.

start up.

•

Hold down the POWER button 1 second or longer to start up.

•

The unit cuts out.

To reduce battery consumption, the unit is automatically shut

down after 10 minutes of inactivity. Select [SETTING]  [AUTO

POWER OFF] in the setting menu to check.

•

The unit cuts out

Check whether the battery is depleted. The battery is depleted

when the battery charge indicator flashes or the [

soon after being

cation appears. Charge the battery or replace it with a freshly

started up.

charged battery.

Battery issues

Symptom

•

The battery is

Check whether the battery is fully charged. Continue charging

until the CHARGE lamp on the charger goes out.

quickly depleted.

•

Check whether the unit is being used in a low-temperature

environment. Battery operation is affected by temperature and

battery life will decrease when used at a low temperature.

•

Check whether the battery has reached the end of its service

life. The battery has a limited life span. The life span of the

battery varies depending on how it is used. The battery has

reached the end of its service life when it depletes quickly, even

after being fully charged.

Do not use benzene or thinner for cleaning.

• Benzene and thinner could deform the unit and cause the paint to peel off.

• Disconnect the battery and the AC power supply cable from the wall outlet before cleaning.

• Wipe the unit using a soft clean cloth. Stubborn soiling should be removed using a cloth dampened with a

solution of a neutral detergent and water. Then wipe with a dry cloth.

Condensation occurs due to the same principle involved when droplets of water form on a window pane of a

heated room. It occurs when this unit or a card is moved between places where the temperature or humidity

varies greatly or when, for instance:

• It is moved to a very humid place full of steam or a room immediately after it has been heated up.

• It is suddenly moved from a cold location to a hot or humid location. When moving the unit to locations

such as these, leave it standing for about 10 minutes rather than switching on the power immediately.