Table of Contents
Advertisement
6. Configure
LAN
7. Configure
SNMP
Avaya, Inc.
You must restart the PARTNER ACS 1600 DSL module for
any changes to take effect.
restarting the PARTNER ACS 1600 DSL module, see the
"PARTNER ACS 1600 DSL module basics" chapter.
Displays the LAN Configuration Menu, which contains the
following command:
F. Set/Clear Full Duplex
Enables and disables full duplex Ethernet mode, which allows
simultaneous transmission and receipt of Ethernet packets.
Type the number of the port, select enable or disable, and
then press ENTER.
Your settings display in the Display Current Configuration
command in the Reports Menu. For more information, see
"Reports Menu" earlier in this chapter.
Displays the SNMP Configuration Menu, which contains the
following commands to configure the simple network
management protocol (SNMP):
E. Enable/Disable SNMP
Enables and disables SNMP.
P. Configure System Contact
Sets the name of the SNMP contact person (maximum = 39
alphanumeric characters).
information, and then press ENTER.
N. Configure System Name
Sets the name of the SNMP host server (maximum = 39
alphanumeric characters). Type the descriptive information,
and then press ENTER.
L. Configure System Location
Sets the location of the SNMP host server (maximum = 39
alphanumeric characters). Type the new location information,
and then press ENTER.
- 58 - PARTNER ACS 1600 DSL module User Guide
For more information on
Type the new system contact
Advertisement
Table of Contents
