AT&T PARTNER II Release 3.1 Programming And Use Instructions page 180

Valid Entries
1 = Assigned
2 = Not Assigned
3 = Select Button (then press a line button to assign the line to that button)
Programming
To assign lines to a specific extension:
Press [
1.
Feature
display reads:
LineAssign
Extension:
2. Enter the extension number to be programmed (10–57). For example, to
program extension 15, press [
A red light appears next to each line button that has a line assigned. To
remove all existing line assignments, press [
line. After this point, pressing [
Enter the line number (01–24) to be assigned. For example, to select line 1,
3.
press [ ] [
0
4. At this point:
If you want to assign the line to the first available button with lights on
the system phone, press [
LineAssign 15 L01
1 Assigned
If you want to remove a line assignment, press [
display reads:
LineAssign 15 L01
2 Not Assigned
If you want to assign the line to a specific button, press [
reads:
Line Assign 15 L01
3 Select Button
Then press a line button to assign the line to that button. If you use
option 3 after a line has been assigned, the line moves from the old
button to the new button you select.
At this point:
5.
To program another line for this extension, press [
until the correct line number shows on the display. Then repeat Step 4.
To program another extension, press [
begin at Step 2.
6. Select another procedure or exit programming mode.
] [ ] [ ] [
0 0 System Program
] [ ].
1 5
Remove
].
1
Next Data
] [ ] [ ] [ ] [
System Program # 3 0
] before selecting a
Remove
] removes only the specified line.
] until the display reads:
] until the
Next Data
3
Next Item
] [
Next Procedure Prev Procedure
Line Assignment (#301)
] [ ]. The
1
]. The display
] or [ ]
Prev Item
] and
5-97