AT&T MERLIN LEGEND Release 3.0 System Programming And Maintenance Manual page 24

Installing the SPM Software
Does one of the following:
Creates the SPM configuration file c:\spm\ams.cfg, if it does not
already exist. In this case, the ares.cfg file consists of only one line,
in which the language attribute is specified: LANG 1 if you specified
English or did not specify a language with the install command;
Modifies the ares.cfg file, if it already exists, by adding or changing
the LANG value.
Follow the steps below to install SPM on the PC'S hard disk.
1 Switch to Drive A, if it is not already the current drive.
A:> appears on the screen.
Insert the backup copy of the SPM diskette into Drive A.
2
3 Type one of the commands shown below and press (Enter
install spanish
Because English is the default language, install and install english have
the same result. If you do use the language argument (english, french, or
spanish), you must type it in lowercase letters as shown. The command
install may be upper case or lower case.
Wait for the message shown below to appear.
4
SPM1 HARD DISK INSTALLATION PROGRAM
Strike a key when ready
Press any key to begin the installation.
5
When the installation is finished, the following message appears:
SPM HARD DISK INSTALLATION IS NOW COMPLETE
YOU MUST REBOOT YOUR SYSTEM BEFORE USING SPMl
6 Remove the SPM diskette from Drive A and reboot your system.
The installation procedure is complete. Go to "Initializing the SPM Software. "
6 System Programming and Maintenance (SPM)
↵
) .