AT&T MERLIN LEGEND Release 3.0 System Programming And Maintenance Manual page 26

Installing the SPM Software
Follow the steps below to perform the SPM initialization.
Type spm and press (Enter
1
S t e p 2 .
Make your entry at the C:> prompt if your PC has a hard disk.
Make your entry at the A:> prompt if you are using the floppy drive.
Press any key.
2
Welcome to SPM
The MERLIN LEGEND
System Programing
& Maintenance Utility
Please press any key
to continue
Version X.XX
The screens shown in Steps 3 through 7 appear only if the system has not
been initialized. Otherwise, the screen shown in Step 8 appears.
Select the serial communications port used for SPM and press (Enter
3
COMM PORT:
1. Comm 1
2. Comm 2
Enter selection #
4
Select the communications port speed and press (Enter
speed
1. 1200
2. 2400
Enter selection #
8
System Programming and Maintenance (SPM)
↵
) to display the SPM Welcome screen shown in
X.XX = current version of SPM
4
Type 1 for serial port 1 (COM1).
Type 2 for serial port 2 (COM2).
Type 1 for 1200 bps.
Type 2 for 2400 bps.
↵
) .
↵
) .