AT&T MERLIN LEGEND Release 3.0 System Programming And Maintenance Manual page 49

Using SPM
5 Type the new filename and press (Enter
Press ESC to
Enter filename:
(*fault is backup.ams)
You can specify a drive letter with the filename but no path information.
6 Verify that the filename chosen does not already exist.
The following screen appears only if the filename chosen already exists.
Continue with Step 7 if this screen does not appear.
The file already exists.
If you continue, the old
version will be deleted.
Press ESC to abort.
Press "c" to continue.
7 Observe the backpstaus screen
Press ESC to Abort.
Est. Blocks: xxx
filename
BACKUP IN PROGRESS
Received Block xx
SPM indicates the status of the backup by displaying the number of the last
block received (xx). Line 2 of the display screen shows the estimated number
of blocks to be sent from the control unit (
are backing up from Release 1.0.
If you abort the backup, the partial backup file is deleted to prevent
restoration from a corrupted file and you see the screen shown in Step 8.
If you are working from the floppy drive,
Abort.
A:\
Press (Esc) to abort the backup. Go to
Step 1 to create a different backup file.
Press (C) to continue. Go to Step 7.
flename = the backup filename specified
xxxx
-
System Programming and Maintenance (SPM) 31
↵
) .
appears on the screen.
in Step 5
- ). This line is blank if you
XXX XXXX