AT&T MERLIN 1030 Installation Manual page 21

Make sure you have the following:
System directory
One comes in the Control Unit Installation Kit.
Line cords
One 7-foot line cord for each outside line. Five come in the Control Unit
Installation Kit, and others are packed with each Line Module.
Green-on-white cord labels
Labeled A0, A1, A2, etc. (two for each line cord), they come in the Control
Unit Installation Kit.
Now do as follows:
1
Decide which outside line number to assign to each Line Module jack
in the control unit.
IMPORTANT: Feature Module 3 creates a one-to-one correspondence
between the jacks in the Line Modules and the jacks in the Voice Ter-
minal Modules. If you have Feature Module 3, be aware that you are
assigning outside lines to specific voice terminals as you decide which
outside line number to assign each Line Module jack.
2
Write the telephone number assigned to each Line Module jack on the
appropriate line in the system directory.
3
Label each line cord at both ends with the green-on-white labels. Be
sure the labels at both ends of each cord match.
4
Starting with the line cord labeled A0, plug one end of the line cord into
the top jack on the Line Module in the slot labeled Lines A0-A4.
5
Thread the cord through the cord clip above the module on the top front
edge of the control unit and then through the corresponding cord clip
to the rear of the control unit.
6
Referring to your system directory, plug the other end of the line cord
into the jack (in the jack field or at the network interface) for the outside
line you've assigned to the Line Module jack.
7
Follow the same procedure with the remaining line cords until you've
connected all the outside lines to the control unit (and the expansion
unit if you have one).
TIP: You can thread cords from two Line Modules (up to 10 cords) through each
cord clip. You may want to use cable ties to tie the cords at various points
between the rear cord clips and the jack field.
6
3
5
2
4
19