Connect Each Voice Terminal To The System - AT&T MERLIN 1030 Installation Manual

CONNECT EACH VOICE TERMINAL TO THE SYSTEM

1
Place each voice terminal in its designated location.
2
Plug the loose end of the modular voice terminal cord into the modular
wall jack.
A red light comes on next to a button.
3
Slide the T/P switch to T and hold it there.
All the red and green lights on the voice terminal begin to flash, and a
tone sounds.
If the lights do not flash, make sure the green power light is lit on each
Power Module in the control unit, and check the wiring connections
associated with that voice terminal (circled in the drawing, right).
If the tone does not sound, make sure the voice terminal's volume con-
trol switch is set in the center position.
If the tone still does not sound and/or the lights do not flash, make a
note of it, and refer to the Troubleshooting Table, page 30, when you've
completed the installation.
Slide the T/P switch to the center position.
4
The lights stop flashing, and the tone stops.
NOTE: If you need to connect a voice terminal directly to the control unit (for
example, to perform system tests or to program system restrictions), plug the
voice terminal cord directly into one of the jacks in a Voice Terminal Module
in the control unit.
1
2
23