Connect The Control Unit To The Ac Outlet - AT&T MERLIN 1030 Installation Manual

CONNECT THE CONTROL UNIT TO THE AC OUTLET

1
Check the power switch on the Power Module in the control unit. Make
sure it is set to Off. If you have an expansion unit, it may have as many
as two additional Power Modules. Make sure the expansion unit's power
switches are set to Off, too.
2 Plug one end of the power cord into the outlet above the control unit
power switch on the Power Module. Run the cord over the top of the
control unit, or between the control unit and the expansion unit, and
plug the other end of the cord into the ac wall outlet. Do the same for
the expansion unit, if you have one. The control unit should be close
enough to the outlet to allow some slack in the cord.
3
If you have an expansion unit, set its power switch(es) to On first. Now
set the power switch on the control unit to On.
The green light on the Power Module comes on and stays on.
The red warning light on the Processor Module comes on and then goes
off after a few seconds.
NOTE: These are the normal system responses. If your system
responds differently, see the table, below.
4
Unless otherwise instructed, leave the power switch(es) set to On
throughout the remaining installation procedures.
If Then
the green light your electrical
on the Power outlet may be
Module does faulty.
not come on
the outlet is in your control unit
working order may be faulty.
the red warning one or more of
light on the Pro- the modules
cessor Module may be loose.
remains on
the red light re- your control unit
mains on may be faulty.
16
Do This
Turn off the control unit. Unplug
the power cord(s) from the ac
outlet. Test the outlet by plugg-
ing in an appliance such as a
lamp or a radio.
Call your equipment supplier
before proceeding with
installation.
Turn off the control unit. Pull out
each module and reinsert it.
Make sure each module is firmly
seated in its slot. Set the power
switch back to On.
Turn off the control unit, and call
your equipment supplier before
proceeding with the installation.
2
1
Power light
3
Warning light