System Tests; Test The Jacks In The Voice Terminal Modules For A Dial Tone; Place An Outside Call - AT&T MERLIN 1030 Installation Manual

System Tests

Now that your system equipment is in place, you need to test it to make sure
it is operating properly. The following tests help you determine if you have
installed your system correctly and if all your system components are operable.
If these tests reveal any problems, refer to the Troubleshooting Table on page 30.

TEST THE JACKS IN THE VOICE TERMINAL MODULES FOR A DIAL TONE

1
Move a 34-button deluxe voice terminal to the control unit.
2
Unplug the jumper cord from the Voice Terminal Module jack for inter-
com 10, and plug the voice terminal's modular line cord into the jack.
The red light goes on next to the middle button in the left row of flat
buttons.
3
Touch the fifth button down in the leftmost row of buttons (Intercom-
Ring); then pick up the handset and verify a dial tone.
The green and red lights go on next to the button.
4
Repeat this step for every intercom and line button on the voice terminal.
5
Repeat this procedure for every Voice Terminal Module jack you want
to test.
If there is no dial tone at one or more line buttons, refer to the Troubleshooting
Table on page 30.

PLACE AN OUTSIDE CALL

Using the same voice terminal at the control unit or any other voice terminal
connected to the system:
1
Lift the handset.
The green light goes on next to the red light.
2
Dial an outside number (for example, a friend's home).
3
After the call is answered, place the call on hold by touching Hold.
The green light next to the line button flashes rapidly.
4
Return to the call on hold by touching the line button next to the flashing
green light.
5
Verify two-way communication, then hang up the handset.
6
If you have performed this test at the control unit, unplug the voice ter-
minal from the control unit, plug the jumper cord into the intercom 10
jack, and return the voice terminal to its office location.
26
1
2
1
2
3
4
5
3