ECS 649-M2 Manual page 67

5 Once the array has been created, you will need to FDUSK and FORMAT the
array as if it were a new single hard drive.
Creating a JBOD Array
• SiS965 enables users to create a JBOD array with 2, 3, or 4 drives.
• SiS965L enables users to create a JBOD array with 2 drives.
To create an JBOD array, follow these steps:
1 Press <A> to start creating a RAID array.
2 Press <1> and <Enter> to select JBOD.
3 You will have two selections to create a JBOD array. The default value is
<1>. If you select <1>Auto Create, you can create a JBOD array faster and
easier. The result after creating will be show on step 5. Besides, you also
can select <2>Manual Create, see following steps.
4 Use < ↑ > < ↓
When you press <Enter> on the disk you wanted, the RAID Type will be
changed from Single to JBOD.
5 After all steps finished, press <Q> until escape the setup menu and JBOD
array will be show on the top of the main frame.
SiS965/SiS965L SATA RAID Setup Guide
> to select disk, and press <Enter> to select disk, <Q> to exit.
61