ECS 649-M2 Manual page 66

60
8
9
Creating a RAID 0+1 (Stripe-Mirror) Array
•
•
•
•
To create an a Stripe-Mirror array, follow these steps:
1
2
3
4
Press <Q> again to exit this BIOS utility and the red message frame will show
as the same as the creation of the RAID 0 array. Press <Y> and <Enter> to
save changes.
Once the array has been created, you will need to FDISK and format the array
as if it were a new single hard drive.
Only SiS965 controller can support RAID 0+1 function
The selection of RAID 0+1 will appear when 4 single HDD existing.
For user's convenience, RAID 0+1 will be auto created.
For best performance, the sequence of RAID 0+1 is forced to set as Disk1->
Disk 3-> Disk 2-> Disk 4.
Press <A> to start creating a RAID array.
Press <4> and <Enter> to select RAID 0+1.
After step 2, RAID 0+1 array will be shown on the top of the main frame.
Press <Q> until exit this BIOS utility RAUID Setup menu and the red message
frame will show as the same as the creation of the RAID 0 array. Press <Y>
and <Enter> to save changes.
SiS965/SiS965L SATA RAID Setup Guide