ECS 649-M2 Manual page 30

24
IRDA: Infrared header
The motherboard supports an Infrared data port. Infrared ports allow the wireless exchange
of information between your computer and similarly equipped devices such as printers,
laptops, Personal Digital Assistants (PDAs), and other computers.
Pin
1
2
3
4
5
WOM: Wake On Modem connector
If you have installed a modem, use the cable provided with the modem to plug into the
WOM connector onboard. This enables the Wake On Modem (WOM) feature. When your
system is in a power-saving mode, any modem signal automatically resumes the system. You
must enable this item using the Power Management page of the Setup Utility in the BIOS.
See Chapter 3 for more information.
Pin
1
2
3
WOL: Wake On LAN connector
If you have installed a LAN card, use the cable provided with the card to plug into the WOL
connector onboard. This enables the Wake On LAN (WOL) feature. When your system is
in a power-saving mode, any LAN signal automatically resumes the system. You must
enable this item using the Power Management page of the Setup Utility in the BIOS. See
Chapter 3 for more information.
Pin
1
2
3
Signal Name
VCC IR power
KEY No pin
IRRX IrDA serial input
GND
IRTX
Signal Name
5VSB +5V stand by power
GND Ground
Ring# Wake up signal (low active)
Signal Name
5VSB +5V stand by power
GND Ground
Ring# Wake up signal (low active)
Installing the Motherboard
Function
Ground
IrDA serial output
Function
Function