LaCie 5big Storage Server Technical Brief page 9

LaCie Professional Server
Technical Brief: RAID
Fastening a disk to the drive tray:
1. Find a suitable work area with adequate space and a flat, even
surface.
2. Locate the empty 5big drive tray and four drive tray screws in-
cluded in your packaging. Do not fasten a disk to a 5big enclo-
sure drive tray with alternative screws. Doing so may damage
the drive tray as well as your non-LaCie disk. Make certain that
your non-LaCie 3.5" SATA II disk and a Phillips head screw-
driver are within reach as well. Please confirm that the head
of the screwdriver is the proper size for the drive tray screws
provided by LaCie.
3. Place the empty drive tray onto the flat work area. The handle
should be on the bottom left, with the lock icon pointing away
from you (Fig. 06).
4. With its label side facing up, gently place the hard disk within
the drive tray (Fig. 07). The four tray screw slots should be neatly
aligned with the disk's four screw holes. Please note that the
printed circuit board will be flat on the work space and the SATA
connector facing to the right.
5. Using the Phillips head screwdriver, carefully fasten all four
screws into their slots. Do not overly tighten the screws. Do-
ing so may negatively affect the integrity of the screw holes on
the drive as well as the threads on the screws
6. Go to 3.7. Insert a Disk for details on inserting the disk tray into
the 5big enclosure.
Fig. 06
(Fig. 08).
Fig. 07
Fig. 08
5big Enclosure: Disk Install
page 9