Fastening A Non-Lacie Hard Disk To The 5Big Enclosure Drive Tray - LaCie 5big Storage Server Technical Brief

LaCie Professional Server
Technical Brief: RAID
3.5. Fastening a non-LaCie Hard
Disk to the 5big Enclosure Drive
Tray
IMPORTANT INFO: Drives sold by LaCie are the preferred choice
for your 5big Storage Server. LaCie disks specially prepared for the
5big enclosure are tested and shipped in a drive tray for easy instal-
lation. Additionally, all 5big hard drives include a 3-year warranty.
Visit www.lacie.com for more information on purchasing a 5big disk
drive.
Please note the following before fastening your non-LaCie hard
drive to the drive tray:
✦ Only 3.5" SATA II drives may be used in the 5big enclosure.
Please visit the Support page at
drives that have been tested by LaCie. LaCie cannot guaran-
tee performance or compatibility with the 5big Storage Server
when using non-LaCie drives or drives that have not been
tested by LaCie.
✦ Use only the screws supplied in your packaging when fasten-
ing the non-LaCie hard drive to the drive tray
Drive Tray and Four Screws)
✦ To avoid potential problems caused by electrostatic discharge
(ESD), it is recommended that you do not touch the hard
drive's printed circuit board
touching the hard drive
precaution against ESD, please use an anti-static wristband
or an anti-static mat to ground yourself when handling the
hard drive.
www.lacie.com for a list of
(Fig. 04 - 5big
(Fig. 05 - To prevent ESD, avoid
printed circuit board). As a further
continued on the next page>>
Fig. 04 - 5big Drive Tray and Four Screws
Fig. 05 - To prevent ESD, avoid touching the hard drive
printed circuit board
5big Enclosure: Disk Install
page 8