Small Computer System Interface (Scsi) Messages - IBM 622138U - IntelliStation Z - Pro 6221 User Manual

Code Function
302 Mouse
305 Video monitor
405 Ethernet
415 Modem

Small computer system interface (SCSI) messages

If you receive a SCSI error message when running the SCSISelect Utility program,
one or more of the following might be causing the problem:
v A failing SCSI device (adapter or drive)
v An improper SCSI configuration
v Duplicate SCSI IDs in the same SCSI chain
v An improperly installed SCSI terminator
v A defective SCSI terminator
v An improperly installed cable
v A defective cable
To solve the problem, verify that:
v The external SCSI devices are turned on. External SCSI devices must be turned
v The cables for all external SCSI devices are connected correctly.
v The last device in each SCSI chain is terminated properly.
v The SCSI devices are configured correctly.
Result Text message
Failed On system-board pointing device test failed.
Any message
Failed In PCI slot n
(where n is the PCI slot number in which the
failing Ethernet adapter is installed)
On system board
Failed Any failure message
on before the computer.
Action
1. Verify that the
pointing device cable
is connected to the
correct port (not the
keyboard port).
2. Replace the pointing
device.
3. If the problem
remains, call for
service.
See the information that
came with the monitor.
1. Verify that Ethernet is
enabled in BIOS.
2. Replace the Ethernet
adapter in slot n.
3. If the problem
remains, call for
service.
1. Verify that Ethernet is
enabled in BIOS.
2. If the problem
remains, call for
service.
1. Check modem cable.
2. Replace modem.
3. If the problem
remains, call for
service.
Chapter 5. Solving problems
77