IBM 622138U - IntelliStation Z - Pro 6221 User Manual page 62

10. Determine whether the drive is an IDE or SCSI device; then, connect one end
11. Route the signal cable so that it does not block the air flow to the rear of the
12. Connect the power cable to the back of the drive. The connectors are keyed
13. If you have other options to install or remove, do so now.
14. Replace the support bracket (see "Removing and installing the support
15. Replace the side cover (see "Replacing the side cover" on page 53).
40
IBM IntelliStation Z Pro Type 6221: User's Guide
7. Touch the static-protective package containing the drive to any unpainted metal
surface on the computer; then, remove the drive from the package and place it
on a static-protective surface.
8. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
Note: You might find it easier to install the new drive into the appropriate
opening on the front, and then attach the cables.
9. If you are installing a 5.25-in. drive in bay 2, push the drive into the bay; then,
use the two screws to attach the drive to the drive cage. If you are installing a
3.5-in. drive in bay 2, you must attach the 5.25-in. conversion kit, supplied with
your option, to the 3.5-in. drive.
of the appropriate signal cable into the back of the drive and make sure that
the other end of this cable is connected into the appropriate IDE or SCSI
connector on the system board. See "Power and signal cables for internal
drives" on page 43 for additional information about cabling drives and
"System-board internal connectors" on page 29 for the location of IDE and
SCSI connectors on the system board. If there are open connectors on the
cables connecting an existing IDE drive, this cable can be used to connect the
new drive. The 3-connector SCSI cable that comes with your computer cannot
be used to connect a SCSI drive in bay 2.
drives or over the microprocessor and memory.
and can be inserted only one way.
bracket" on page 33).
EMC shield
Filler panel
13 94