Table of Contents
Advertisement
14. Replace the support bracket (see "Removing and installing the support
15. Replace the side cover (see "Replacing the side cover" on page 53).
16. Reconnect the external cables and power cords. Turn on the attached devices,
Installing a security rope clip
To help prevent theft, you can add a security rope clip and cable to your computer.
Complete the following steps to install a rope clip:
1. Turn off the computer and all attached devices.
2. Disconnect all power cords; then disconnect all external cables.
3. Remove the side cover (see "Removing the side cover" on page 31).
4. Use a screwdriver to remove the two metal knockouts.
5. Insert the rope clip through the rear panel; then, attach and tighten the nuts.
6. Thread a cable through the rope clip and around an object that is not part of or
7. If you have other options to install or remove, do so now.
8. Replace the side cover (see "Replacing the side cover" on page 53).
9. Reconnect the external cables and power cords. Turn on the attached devices,
bracket" on page 33).
and turn on the computer.
permanently secured to the building structure or foundation, and from which the
cable cannot be removed. Fasten the cable ends together with a lock. After you
add the security cable, be certain it does not interfere with other cables
connected to the computer.
Rope clip
and turn on the computer.
Chapter 4. Installing options
51
Advertisement
Table of Contents
Troubleshooting
