Using Passwords; Using The Lsi Logic Configuration Utility Program - IBM 622138U - IntelliStation Z - Pro 6221 User Manual

v PC Health Status
v Error Logs
v Save Settings
v Restore Settings
v Load Default Settings
v Exit Setup

Using passwords

You can use any combination of up to seven characters (A–Z, a–z, and 0–9) for the
user (power-on) password or the administrator password. When you have set one
or both of the passwords, record the passwords and keep them in a secure place.
If both a user and administrator password are set, you can type either password at
the password prompt that appears as you start your computer. However, if you want
to change the settings in the Configuration/Setup Utility program, you must type the
administrator password to access the full configuration menus. If you type the user
password, you can only view limited information in the Configuration/Setup Utility
program.
Keep a record of your password in a secure place. If you forget the user or
administrator password, you can regain access to the computer through one of the
following methods:
v If you have forgotten the user password and an administrator password is set,
v Clear CMOS settings by changing the position of the CMOS recovery jumper
v Remove the battery and then install the battery. See "Replacing the battery" on

Using the LSI Logic Configuration Utility program

LSI Logic Configuration is a built-in, menu-driven configuration utility program that
you can use to:
v Perform a low-level format of a SCSI hard disk drive
v Set a SCSI device scan order
v Set a SCSI ID for a controller
24
IBM IntelliStation Z Pro Type 6221: User's Guide
Select this choice to display the computer temperature and voltage status, and
fan speeds.
Select POST Error Log to view the three most recent error codes and messages
that the system generated during POST.
Select Clear event/error logs from the POST Error Log menu to clear the
POST Error Log.
Select this choice to save your customized settings.
Select this choice to delete your changes.
Select this choice to cancel your changes.
If you have made any changes and not saved them, the program will prompt you
to save the changes or exit without saving the changes.
type the administrator password at the power-on prompt. Start the
Configuration/Setup Utility program and change the user password.
(JBAT1). See "Erasing a lost or forgotten password (clearing CMOS)" on page 89
for instructions.
page 90 for instructions.