Table of Contents
Advertisement
ttt
iii
date
cc
text message
Text messages
The diagnostic text message format is as follows:
Function Name: Result (test specific string)
where:
Function Name
Result
Test Specific String
Starting the diagnostic programs and viewing the test log
The test log records data about system failures and other pertinent information. The
test log will not contain any information until after the diagnostic program has run.
Note: If you already are running the diagnostic program, begin with step 4.
is the three-digit failure code for the exact test failure. (These codes are for
trained service personnel and are described in the Hardware Maintenance
Manual.)
is the three-digit device ID. (These codes are for trained service personnel
and are described in the Hardware Maintenance Manual.)
is the date that the diagnostic test was run and the error recorded.
are the check digits that are used to verify the validity of the information.
is the diagnostic message that indicates the reason for the problem.
is the name of the function being tested when the error occurred. This
corresponds to the function code (fff) given in the previous list.
can be one of the following:
Passed
This result occurs when the diagnostic test is completed without
any errors.
Failed This result occurs when the diagnostic test discovers an error.
User Aborted
This result occurs when you stop the diagnostic test before it is
complete.
Not Applicable
This result occurs when you specify a diagnostic test for a device
that is not present.
Aborted
This result occurs when the test could not proceed because of the
system configuration.
Warning
This result occurs when a possible problem is reported during the
diagnostic test, such as when a device that is to be tested is not
installed.
is additional information that is used to analyze the problem.
Chapter 5. Solving problems
73
Advertisement
Table of Contents
Troubleshooting
