Installing A Security Rope Clip - IBM IntelliStation M Pro Hardware Maintenance Manual

10. Insert the DIMM into the connector. Firmly press the DIMM straight down into
11. If you have other options to install or remove, do so now. Otherwise, rotate the
12. Replace the cover (see "Replacing the cover" on page 47).
13. Reconnect the external cables and power cords. Turn on the attached devices,

Installing a security rope clip

To help prevent hardware theft, you can add a security rope clip and cable to your
computer. After you add the security cable, make sure that it does not interfere with
other cables that are connected to the computer.
46
IBM IntelliStation M Pro Types 6220 and 6230: Hardware Maintenance Manual
Table 3. Memory installation sequence
DIMMs
1 DIMM
2 DIMMs
4 DIMMs
7. Open the retaining clips and, if necessary, remove any existing DIMM.
8. Touch the static-protective package containing the DIMM to any unpainted
metal surface on the computer. Then, remove the new DIMM from the
package.
9. Gently open the retaining clip on each end of the DIMM slot. Turn the DIMM
so that the pins align correctly with the connector.
the connector by applying pressure on both ends of the DIMM simultaneously.
The retaining clips snap into the locked position when the DIMM is firmly
seated in the connector. If a gap exists between the DIMM and the retaining
clips, the DIMM has not been correctly installed. Open the retaining clips,
remove the DIMM, then reinsert it.
DIMM
connector 1
drive cage back into the computer, and replace the support bracket (see
"Removing and installing the support bracket" on page 35.
and turn on the computer.
Slots
1
1, 3
1, 2, 3, 4
DIMM
connector 2
DIMM
connector 3
DIMM
connector 4