Installer Checklist; To Clean And Protect Exterior Surfaces - Thermador PRD366EG Installation Instructions Manual

INSTAL RCHECKLIST
FINAL CHECK LiST
[]
[]
Specified clearances main-
tained to cabinet surfaces.
Unit Level - front to back -
side to side.
[]
[]
[]
Burner caps positioned prop-
erly on burner bases.
All packaging material removed.
Island trim or backguard at-
tached according to instruc-
tions.
[] Kick panel in place and two (2)
screws secure.
[]
The grill and/or griddle plate is
correctly positioned, tilted
slightly forward. (See page 9for
adjustment procedure.)
GAS SUPPLY
OPERATION
[] The appliance is connected []
only to the type of gas for which
it is certified for use.
[]
[]
Manual gas shut off valve in-
stalled in an accessible loca-
tion (without requiring removal
of range).
Unit tested and free of gas
leaks.
[]
[]
[]
If used on propane gas, verify []
that the propane gas supply is
equipped with its own high pres- []
sure regulator in addition to the
pressure regulator supplied
with the appliance.
[]
Receptacle with correct over-
current protection is provided
for service cord connection.
[] Proper ground connection.
Bezels centered on burner
knobs, and knobs turn freely.
Each burner lights satisfacto-
rily, both individually and with
other burners operating.
Oven door hinges seated and
door alignment is in proper po-
sition. Door opens and closes
properly.
Burner grates correctly posi-
tioned.
INSTALLER: Leave the Care
and Use Manual and Installa-
tion Instructions with the owner
of the appliance.
To Clean and Protect Exterior Surfaces
The stainless steel surfaces may be cleaned by
wiping with a damp soapy cloth, rinsing with clear
water and drying with a soft cloth to avoid water
marks. Any mild glass cleaner will remove finger-
prints and smears.
For discolorations or deposits that persist, refer to the
Care and Use Manual.
To polish and protect the stainless steel, use a cleaner!
polish such as Stainless Steel Magic '_.
DO NOT allow deposits to remain for long periods of
time.
DO NOT use ordinary steel wool or steel brushes.
Small bits of steel may adhere to the surface causing
rust.
DO NOT allow salt solutions, disinfectants, bleaches
or cleaning compounds to remain in contact with
stainless steel for extended periods. Many of these
compounds contain chemicals which could prove
harmful. Rinse with water after exposure and wipe
dry with a clean cloth.
2O