And Grounding - Thermador PRD366EG Installation Instructions Manual

Step 6: Electrical Requirements, Connection & Grounding
A 3- or 4-conductor supply may be connected to the
terminal block.
3-WIRE LEAD CONNECTION
1. Remove upper nuts only from the terminal block
studs. Do not remove nuts which secure range
interna_ wiring _eads.
2. Secure the neutral, grounded wire of the supply
circuit, to the center stud of the terminal block with
nut. (See Fig. 10).
3. Secure the LI (black) and L2 (red) power leads to
the outside terminal block studs (brass colored)
with nuts.
4. Tighten nuts securely,
4-WIRE CONNECTION
.
.
.
Remove upper nuts only from the terminal block
studs. Do not remove lower nuts which sen
cure range internal wiring _eads.
Remove ground strap screw and bend the strap
up as shown in Fig. 11.
Secure the neutral wire to the center stud of the
terminal block with nut.
4. Secure the LI (black) and L2 (red) power leads to
the outside terminal studs (brass colored) with
nuts.
.
Secure the bare copper ground lead to the range
chassis using the ground screw previously used
for the ground strap. Be sure that neutral and
ground terminals do not touch.
6. Tighten all connections securely.
F_G. 9
FIG. 10
Conductor Securement
Upper Nut
!pply Wire
Flat Washer
3 Wire Connection
LI Black
F_G.11
Ground Strap
L2 Red
Neutral White
LI Black'_
Red
15