Step 6: Electrical Requirements; Connection And Grounding - Thermador PRD366EG Installation Instructions Manual

Step 6: Electrical Requirements, Connection & Grounding
Prior to installing appliance, always disconnect
appliance electrical supply cord, if so equipped,
from wall receptacle. If appliance is hard-wired to
power supply, disconnect power to unit by turning
off the proper circuit breaker or disconnecting the
proper fuse. Lock service panel to prevent power
from being turned ON accidentally.
Dual Fuel range models can be connected or hard-
wired to the power supply as described on Page 15.
Chart B: Electrica_ SuppJy Circuit Requirements
MODEL TYPE VOLTAGE CURRENT
30" 240/208 VAC 35 Amps
36" 240/208 VAC 35 Amps
48" 240/208 VAC 50 Amps
FREQUENCY PHASE
60 Hz. Single
60 Hz. Single
60 Hz. Single
A neutral supply wire must be provided from the
power source (breaker/fuse panel) because criti-
cal range components, including the surface
burner spark re-ignition module, require 120 VAC
to operate safely and properly. An improper 120/
240 VAC power supply will cause malfunction,
damage tMs appliance, and possibly create a
condition of shock hazard. If the correct power
supply circuit is not provided, it is the responsibil-
ity and obligation of the installer and user to have
proper power supply connected. This must be
accomplished in accordance with all appficable
local codes and ordinances by a qualified electrk
cian. In the absence of local codes and ordk
nances, the power supply connection shall be in
accordance with the National Electric Code.
• Observe all governing codes and ordinances
when grounding. In the absence of these codes
or ordinances observe National Electrical Code
ANSIiNFPA No. 70 current issue. See Pages 15
and 16 for grounding method,
• Electrical wiring diagrams and schematics have
been placed in the toe kick area of the range for
access by a qualified service technician,
• The ranges are to be connected to a 240/208
VAC power supply.
CAUTION
The appliance must be isolated from the gas supply piping system by closing its individual manual shut-
off valve during any pressure testing of the gas supply piping system at test pressures equal to or less
than 1/2 psig (3.5 kPa.).
The appliance and its individual shut off valve must be disconnected from the gas supply piping system
during any pressure testing of the system at test pressures in excess of 1/2 psig (3.5 kPa.).
When checking the manifold gas pressure, the inlet pressure to the regulator should be at least 6" W.C.
(14.9 mb) for natural gas or 11" W.C. (27A mb) for propane.
Do not attempt any adjustment of the pressure regulator.
13