HP ML330 - ProLiant - G3 Setup And Installation Manual page 93

RAID Configuration and Management
The setup screen has three menu windows:
•
Array Information
•
Physical Drive Information
•
Help Information
Array Information
IMPORTANT: You cannot add drives or remove drives from an array that already has been
configured, without destroying the data present on the already configured array.
The Array Information window of the setup screen displays all the drive arrays
configured. Use this window to create, delete, or edit the existing configurations.
Press the up arrow and down arrow keys to navigate the properties, and then press the
Enter key to edit your selection. You can create additional arrays in this window. For
more information, refer to the HP ProLiant ML330 Generation 3 Server
Maintenance and Service Guide.
NOTE: To add additional arrays, follow the onscreen steps after an array configuration is
selected. Refer to "Help Information" for more information about arrays.
Physical Drive Information
The Physical Drive Information window displays all the physical drives connected
to the ATA/100 controller channels and their properties. Press the up arrow and down
arrow keys to navigate this window. This window is not editable.
Help Information
IMPORTANT: When running the Configuration Utility, you may see RAID 0+1 displayed in
place of RAID 1+0. RAID 0+1 and RAID 1+0 are used synonymously in this utility.
The Help window displays hints on available options and provides a list of keys that
you can use to perform tasks, such as the following:
•
Switch Windows (Tab)—switches the control back and forth between the Array
Information and the Physical Drive Information windows.
6-4 HP ProLiant ML330 Generation 3 Server Setup and Installation Guide