System Id Switch; Jumper Settings - HP ML330 - ProLiant - G3 Setup And Installation Manual

Component Identification

System ID Switch

The system ID switch is reserved for use by authorized service providers only. Do
not change the indicated default settings.

Jumper Settings

SCSI Device Jumper Settings
No two SCSI devices connected to the same SCSI controller can have the same
SCSI ID. If another SCSI device is connected to the controller, check its SCSI ID
before beginning the installation procedure for the additional device. Jumpers located
on each device set the SCSI ID. For more information, refer to the SCSI device
option documentation.
IDE Device Jumper Settings
When installing any IDE devices (ATA hard drives, ATAPI CD-ROM drives, or
ATAPI tape drives), be sure that the jumper on the device is set to Cable Select (CS).
This setting allows the cable to automatically assign the device ID of an IDE drive
attached to the cable. For information on installing and cabling IDE devices, refer to
Chapter 4, "Hardware Options Installation."
1-10 HP ProLiant ML330 Generation 3 Server Setup and Installation Guide